malibu hard start

1998 CHEVROLET MALIBU
155,000 MILES
Avatar
BUDDY56
  • MEMBER
  • 12 POSTS
i have a 1998 chevy malibu 3.1l. in the morning it will start fine. but afterwards it is very hard to start. also i smell a rich gas smell. i recently did a tune up and changed plugs wires pcv valve fuel and air filter and oil change. also when it warms up it has a slight rough idle and it sounds like it has a small vacuum leak but doesnt set a code.
Jan 2, 2012 at 4:11 AM
Advertisement
Avatar
FIXITMR
  • CERTIFIED EXPERT
  • 9,990 POSTS
check/clean MAF sensor.
Jan 2, 2012 at 4:19 AM
Avatar
FIXITMR
  • CERTIFIED EXPERT
  • 9,990 POSTS
what did old plugs look like? dark?
Jan 2, 2012 at 4:20 AM
Advertisement
Avatar
BUDDY56
  • MEMBER
  • 12 POSTS
i do not remember
Jan 22, 2012 at 7:12 PM
Avatar
FIXITMR
  • CERTIFIED EXPERT
  • 9,990 POSTS
pull a plug and see what it looks like. check fuel pressure regulator vac line for raw fuel (leaking).
Jan 22, 2012 at 9:10 PM
Avatar
BUDDY56
  • MEMBER
  • 12 POSTS
i checked the vacuum line and it does not have any fuel in it. also the plugs look a little red
Jan 24, 2012 at 3:22 AM
Avatar
BUDDY56
  • MEMBER
  • 12 POSTS
also i noticed now when the car is at operating temp it has misfires and sounds like a vacuum leak
Jan 24, 2012 at 3:27 AM
Avatar
FIXITMR
  • CERTIFIED EXPERT
  • 9,990 POSTS
you could try smoke test or tube to ear to try and locate leak?
Jan 24, 2012 at 4:24 AM
Avatar
BUDDY56
  • MEMBER
  • 12 POSTS
can the problem be caused by a bad intake manifold gasket? because i am loosing coolant and i know these cars have a problem with the intake
Jan 27, 2012 at 10:05 PM
Avatar
FIXITMR
  • CERTIFIED EXPERT
  • 9,990 POSTS
do you smell any antifreeze under hood? or see any? you can do pressure test to see if it comes out around manifold.
Jan 28, 2012 at 4:14 AM
Avatar
BUDDY56
  • MEMBER
  • 12 POSTS
there is coolant leaking from the lower intake i am getting it replaced on monday. the engine was burning antifreeze so do you think it would be a good idea to replace the plugs too?
Feb 3, 2012 at 2:21 AM
Avatar
FIXITMR
  • CERTIFIED EXPERT
  • 9,990 POSTS
might as well just to make sure you have good spark at all cylinders.
Feb 8, 2012 at 7:12 PM
Avatar
BUDDY56
  • MEMBER
  • 12 POSTS
i changed the gaskets the plugs and cleaned the maf. but it still has the hard start issue. what else should i check?
Feb 11, 2012 at 3:08 AM
Avatar
FIXITMR
  • CERTIFIED EXPERT
  • 9,990 POSTS
if you give it gas will it start better warm? even try holding to floor if necessary? maybe your temp sensor is out of spec?
Feb 12, 2012 at 8:17 AM
Avatar
BUDDY56
  • MEMBER
  • 12 POSTS
yes that does help sometime holding the gas pedal down works. which temp sensor the iat or ect?
Feb 12, 2012 at 3:22 PM
Avatar
FIXITMR
  • CERTIFIED EXPERT
  • 9,990 POSTS
ect
Feb 12, 2012 at 8:00 PM
Avatar
LWADE214
  • MEMBER
  • 3 POSTS
Did you ever get this hard start problem fixed? I am having similar issues with a 1998 chevy malibu 2.4l
Jun 8, 2014 at 11:20 AM