1998 Buick Skylark Crankshaft position sensor

I dont have a diagram there is two the 7x one is right front side of the engine and the 24x one is front side of engine.

The 24x sensor should be down by the crankshaft pulley. The 7x sensor is on the back side of engine block, down low, get at it from underneath the vehicle. My wiring showed 24x, so I would look for wiring connector around crankshaft pulley. I'll see if I can find a picture?

Below is a picture for the 24x sensor. Passenger side down low, have to remove crankshaft pulley.

Thanks for the assist jdl have a great day.

Hey saturntech9 didn't see your post, before I started looking for info. Wasn't trying to butt in. Have a good day.

No worries jdl were all on the same team here to help out the users better to give them too much help then not enough help.

Thanks for all the help guys! I really need a diagram for the 7x crankshaft sensor if possible. If not I will just have to figure it out.

If it helps you any the 7X sensor has a yellow wire and a purple wire going to it.That should narrow down your search.

Thank you very much. I know exactly where it is now. Thsnks for all the great help guys.

Your welcome thats what were here for glad you found it.