Re turning obd code PO134

1997 SATURN SC1
135,000 MILES
Avatar
BOBAZ1966
  • MEMBER
  • 3 POSTS
I have a 1997 Saturn SC1 Single over head cam. The service engine light is on. I am getting the code PO134 O2 sensor CKT no activity (bank 1 sensor1). I replaced the O2 sensor in the front of the vehicle and reset the Engine light. After I drive the car approximately 10 minutes and run a scan and no code. Another 15 minutes of driving and I get a code PO134 pending. Another 10 minutes or so of driving and the engine light comes on with code PO134. With the engine at normal operating temp. I get 1 volt from the O2 sensor.
Feb 27, 2012 at 10:00 PM
Advertisement
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Do you have a scan tool that reads live engine data?Also have you inspected the o2 sensor wire itself?
Feb 27, 2012 at 11:56 PM
Avatar
RASMATAZ
  • CERTIFIED EXPERT
  • 75,992 POSTS
1volt is an indication of running rich-check the wiring harness and for poor connection



Feb 27, 2012 at 11:57 PM
Advertisement
Avatar
FIXITMR
  • CERTIFIED EXPERT
  • 9,990 POSTS
On the back of the block under the #4 cylinder intake runner right above the starter there is a 10mm bolt screwed into the block. Under that bolt are 4 wires, 2 brown and 2 black with white tracer. These are the grounds for the O2 sensors and the PCM O2 sensor circuitry. Remove the bolt and clean both ring terminals and the block mating area. Clean block and ring terminals with CRC Electronics Component cleaner and reassemble. You can reach these from above.
Feb 28, 2012 at 12:23 AM
Avatar
BOBAZ1966
  • MEMBER
  • 3 POSTS
Thank you My scan tool is only basic. The wiring looks good and intact. I will try to clean the grounds in A M
Feb 28, 2012 at 1:20 AM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Just to add to this one its a 8mm bolt head on it and its the grounds for the tps etc if thats got a bad ground it it will set codes for both front and rear o2 sensors not just the front o2 sensor.Been down that road before but it is worth a look.
Feb 28, 2012 at 1:21 AM
Avatar
BOBAZ1966
  • MEMBER
  • 3 POSTS
Thank you the ground bolt was loose tightened it and fix the trouble
Mar 3, 2012 at 5:53 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Glad to hear it a loose ground can cause strange things to happen.Thanks for the assist fixitmr.
Mar 3, 2012 at 5:56 PM
Avatar
FIXITMR
  • CERTIFIED EXPERT
  • 9,990 POSTS
i get lucky once and awhile!
Mar 8, 2012 at 9:23 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Every dog has his day lol.
Mar 8, 2012 at 10:59 PM
Avatar
FIXITMR
  • CERTIFIED EXPERT
  • 9,990 POSTS
and they all go to heaven!
Mar 9, 2012 at 4:09 AM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Like the disney movie lol.
Mar 9, 2012 at 4:11 AM