1997 ford e150 4.3 code shows #2 cyl mis fire changed plug replaced wire compression ok could it be injector? if so how do u get to the injector
Jan 22, 2011 at 1:36 AM
engine miss
1997 FORD E-SERIES VAN
GORHAMRDG
- MEMBER
- 3 POSTS
- FOLLOW
Advertisement
REMOVAL
1.Remove the Fuel Rail.
CAUTION: The fuel injectors are deposit resistant. Do not clean the fuel injectors.
2.Remove the six fuel injectors.
1 Remove the six injector clips.
2 Remove the six fuel injectors.
3 Remove and inspect the two O-rings from each fuel injector.
- Replace the O-rings as needed.
To install, reverse the removal procedure.
NOTE: Lubricate the new O-rings with engine oil before installation.
CAUTION: Install the injector clips in the uppermost groove of the fuel injectors.
1.Remove the Fuel Rail.
CAUTION: The fuel injectors are deposit resistant. Do not clean the fuel injectors.
2.Remove the six fuel injectors.
1 Remove the six injector clips.
2 Remove the six fuel injectors.
3 Remove and inspect the two O-rings from each fuel injector.
- Replace the O-rings as needed.
To install, reverse the removal procedure.
NOTE: Lubricate the new O-rings with engine oil before installation.
CAUTION: Install the injector clips in the uppermost groove of the fuel injectors.
Image (Click to enlarge)
Jan 22, 2011 at 7:06 AM