Need to change brake light switch, how is this done??
Nov 3, 2012 at 2:40 AM
1997 CHEVROLET CHEYENNE
ANONYMOUS
- MEMBER
- 1 POST
- FOLLOW
Advertisement
Remove or Disconnect
Negative battery cable.
Disable SIR. Refer to Air Bags and Seat Belts.
Retainer from brake pedal pin. Use snap ring pliers.
Switch by unsnapping from pushrod.
Electrical connector from switch.
Install or Connect
Electrical connector into switch.
Switch by snapping it into pushrod.
Retainer onto brake pedal pin. Use 11 mm (7/16 inch) socket to push new clip on pin.
Negative battery cable.
Enable SIR. Refer to Air Bags and Seat Belts.
Negative battery cable.
Disable SIR. Refer to Air Bags and Seat Belts.
Retainer from brake pedal pin. Use snap ring pliers.
Switch by unsnapping from pushrod.
Electrical connector from switch.
Install or Connect
Electrical connector into switch.
Switch by snapping it into pushrod.
Retainer onto brake pedal pin. Use 11 mm (7/16 inch) socket to push new clip on pin.
Negative battery cable.
Enable SIR. Refer to Air Bags and Seat Belts.
Nov 3, 2012 at 3:58 AM