1993 Chevy 3.1 Beretta Coolant fitting

1997 CHEVROLET BERETTA
97,000 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
TEKTOOLS
  • MEMBER
  • 2 POSTS
My son's Beretta (97K miles)started to leak coolant in the drivway when I was not home. Car was just sitting from what I was told. Later when I got home, I jacked up the front end passenger side from front, coolant runs out of a rubber elbow that points down. This elbow comes out of the firewall below the sterring rack. The recovery bottle has fluid in it but cannot tell if some ran out. Bottle is fogged.
What is the elbow fitting coming out of the firewall?
Why if there coolant coming out of it while jacked up?
Aug 2, 2011 at 10:53 PM
Advertisement
Avatar
WRENCHTECH
  • CERTIFIED EXPERT
  • 20,761 POSTS
It sounds like the heater core has sprung a leak and the coolant is drainig through the condensation drain.
Aug 3, 2011 at 12:01 AM
Avatar
TEKTOOLS
  • MEMBER
  • 2 POSTS
Thanks for the reply. I'll order a new core and get the dash apart. I should have know it was from the heater drain, being upside down when looking at it, I thought the elbow was at the top of the heater. Getting old.
As for the engine side, looks like I got to loosen two (2)compression fittings.
Image (Click to enlarge)
Attached Media
Aug 3, 2011 at 10:44 PM
Advertisement
Avatar
WRENCHTECH
  • CERTIFIED EXPERT
  • 20,761 POSTS
You don't have to remove any of the dash on that one. There is a tray under the dash that is removed.
Aug 3, 2011 at 10:52 PM