changing a rear turn signal bulb

Open the trunk and you will find wing nuts that hold the light assembly in place. Remove the wing nuts and light assembly to access the bulbs.

I know this is an old post, but in case someone else is reading this...

Here' the real way:

- Open trunk
- Pull trunk liner to side to gain access to light assembly in trunk
- Find the 2 tabs opposite each other and "squeeze" them together
- Pull the bulb holder circuit board out of the light assembly
- Remove faulty bulb (push in on bulb and turn counterclockwise)
- Install new bulb
- Push Circuit board back into place until you hear 2 clicks
- Put trunk liner back in place

Thomas