Clutch cylinder replacement

1996 JEEP CHEROKEE
140 MILES • 6 CYL • 4WD • MANUAL
Avatar
CARLOSJ40
  • MEMBER
  • 2 POSTS
To change the clutch master cylinder, the line to the slave cylinder is "poly" and locked in place with a roll pin, there is not enough room between the power brakes and fender to drive it (roll pin)out with a drift pin and hammer, is there a special plier type tool? or can you cut the poly line and will it seal with the new O-ring they supply with the new cylinder?
Aug 15, 2011 at 2:35 PM
Advertisement
Avatar
DOCFIXIT
  • CERTIFIED EXPERT
  • 18,828 POSTS
Hydraulic system serviced as unit both master /slave come together bleed ready to go.
Aug 15, 2011 at 3:37 PM
Avatar
CARLOSJ40
  • MEMBER
  • 2 POSTS
Not true! The "master" and come seperate, both come with new
O-rings and roll pins to replace using the original "poly" line.
the roll pin on the slave cylinder is accessable to change. again the roll pin on the Master cylinder is the one in question??
Aug 16, 2011 at 12:07 AM
Advertisement
Avatar
DOCFIXIT
  • CERTIFIED EXPERT
  • 18,828 POSTS
Believe what you want but replacing both as unit much simpler
Aug 16, 2011 at 12:30 PM