1996 town and country, heat problems

1996 CHRYSLER TOWN AND COUNTRY
1 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
JBURGMANN
  • MEMBER
  • 3 POSTS
I have a 1996 Town and country with no heat on the drivers side. I ran a calibration test on the front panel and it said there was a problem with the "ZONE/DRIVER ACTUATOR DID NOT REACH HEAT STOPZONE/DRIVER ACTUATOR DID NOT REACH HEAT STOP" I figured the actuator went bad so I got a new one, replaced it and now i get the code "BLEND PASS. ACTUATOR DID NOT REACH HEAT STOP ". Is this more of a mechanical problem with the doors themselves or did I do something wrong when I installed the actuators?
Thanks,
Jon B
Nov 15, 2010 at 4:28 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • CERTIFIED EXPERT
  • 110,175 POSTS
Jon:
I think the first code was a result of the blend door actuator. If it isn't functioning properly, it will kick the other code. Check the blend door to see if it is sticking or not working at all.
Nov 15, 2010 at 4:30 PM
Avatar
JBURGMANN
  • MEMBER
  • 3 POSTS
how do I see if it is sticking?
Nov 15, 2010 at 4:32 PM
Advertisement