Brake peddle feels like your are stepping on a pop can at times

1996 BUICK REGAL
191,000 MILES
Avatar
FIREMNTED
  • MEMBER
  • 81 POSTS
Peddle is hard for a few seconds and them goes to normal. I have checked for a vacuum leak an none!
Jul 7, 2012 at 2:00 AM
Advertisement
Avatar
ASEMASTER6371
  • CERTIFIED EXPERT
  • 52,796 POSTS
could be a bad booster or the master may be bad. does the car stop ok??

Roy
Jul 7, 2012 at 2:03 AM
Avatar
FIREMNTED
  • MEMBER
  • 81 POSTS
The car stops o.k. It does make a strange sound when I start it in the morning sounds like a linkage binding and the peddle fades about half way but it only does this when I start it and put it in gear with in 20 seconds!
Jul 7, 2012 at 2:06 AM
Advertisement
Avatar
ASEMASTER6371
  • CERTIFIED EXPERT
  • 52,796 POSTS
you may have a master cylinder issue. i would have this checked asap to avoid loosing the brakes and putting yourself in danger

Roy
Jul 7, 2012 at 2:08 AM
Avatar
FIREMNTED
  • MEMBER
  • 81 POSTS
I did a little more looking and fond a small vacuum leak and that seems to have fixed it! But now The lifters are making noise! I have 4000 Miles on the rebuilt engine I had the cam checked before I reused it and was told there is no reason to replace the lifters! The oil light does not come on so I do not believe the oil pump went. I did rebuild the pump with the engine! Any ideas?
Jul 8, 2012 at 12:57 AM
Avatar
ASEMASTER6371
  • CERTIFIED EXPERT
  • 52,796 POSTS
do a manual oil pressure check to verify the actual pressure.

used cam?? new lifters?? not normally done as they are a matched set.

lifters are a common failure in these motors. i would have replaced both if i were rebuilding the motor.

did you do the main, rod bearings and cam bearings in your rebuild??

Roy
Jul 8, 2012 at 1:28 PM
Avatar
FIREMNTED
  • MEMBER
  • 81 POSTS
I put a crank kit in it. I had the machine shop check the cam and lifters they said the cam liked like new and there was no reason to change the lifters> the block was boiled so new cam bearings. What about a stuck check valve in the oil filter I just changed It last weekend?
Jul 8, 2012 at 3:21 PM
Avatar
FIREMNTED
  • MEMBER
  • 81 POSTS
This is the same 3800 I was working with you on a few months ago with the rough Idle at start up I replaced the MAF sensor because the top was cracked!
Jul 8, 2012 at 3:24 PM
Avatar
FIREMNTED
  • MEMBER
  • 81 POSTS
Do you know what the oil pressure should be at Idle I got 70-75 PSI
Jul 9, 2012 at 10:35 PM