Clutch sticks...but works!?

1994 TOYOTA 4RUNNER
125,000 MILES
Avatar
GLENDA L SMITH
  • MEMBER
  • 6 POSTS
We put fluid in resevoir.Clutch does fine until u hold it down for anytime then it sticks?u have to reacxh down and pull it up. We took top off resevoir and pushed on clutch..NO MOVEMENT of fluid at all.Bled it .Any ideas?

Thx,
Glenda
Oct 17, 2011 at 12:56 PM
Advertisement
Avatar
KHLOW2008
  • CERTIFIED EXPERT
  • 41,814 POSTS
The clutch master cylinder is bad and leaking pressure internally. You need to have it repaired or replaced.
Oct 17, 2011 at 4:39 PM
Avatar
GLENDA L SMITH
  • MEMBER
  • 6 POSTS
Thanks so much.We suspected same thing.But verification from u is what we needed.!!LET ME SAY THIS IS A FANTASTIC SITE..WITHOUT DOUBT!!!!!!!!!!!
Oct 17, 2011 at 7:49 PM
Advertisement
Avatar
KHLOW2008
  • CERTIFIED EXPERT
  • 41,814 POSTS
You're welcome.

Have a great day.
Oct 18, 2011 at 1:48 PM
Avatar
GLENDA L SMITH
  • MEMBER
  • 6 POSTS
HELP again!!! new clutch master cylinder but clutch STILL STICKS..aLSO CANNOT GET INTO GEAR.Now what?
Oct 19, 2011 at 7:32 PM
Avatar
KHLOW2008
  • CERTIFIED EXPERT
  • 41,814 POSTS
Did you adjust the master cylinder to pedal push rod clearance correctly?
Too much clearance, meaning the clutch engages at a low pedal height, or insufficient clearance, a high pedal height can cuase the problem described.

Was the system bled correctly?
Is the slave cylinder leaking?

Oct 26, 2011 at 6:47 AM