timing suzuki 1.6 liter 16 valve, 1994

1994 SUZUKI AERIO
137,000 MILES • 4 CYL • 4WD • AUTOMATIC
Avatar
SHVLHEAD68
  • MEMBER
  • 10 POSTS
Thanks for the help on the timing marks, now I need to know if there is a wire that needs to be grounded to set the timing on the distributor. Most cars with EGO and no vacuum advance have a wire that you ground to set the timing. My cheap Hanes manual doesn't say, and it seems to be retarded too much by just using the timing light. So is there a wire that needs grounded, and if so, what does it look like and where is it?
Nov 15, 2010 at 6:26 PM
Advertisement
Avatar
KHLOW2008
  • CERTIFIED EXPERT
  • 41,814 POSTS

There should be a 4 pin connector near the battery that is covered with a plastic/rubber cap.

By bridging terminal C and D you can check the igniton timing and adjust according ly.

C = ground and D = test switch wire.

Sorry I am not able to post any diagrams as the new set-up does have any features to do it.
Nov 15, 2010 at 6:47 PM
Avatar
SHVLHEAD68
  • MEMBER
  • 10 POSTS
There is a 4 pin connector in front of the battery and jumping c and d doesn't do anything. The manual also says to jump b and c to get the check engine to flash the codes. That doesn't do anything, either. Any ideas?
Nov 15, 2010 at 10:46 PM
Advertisement
Avatar
KHLOW2008
  • CERTIFIED EXPERT
  • 41,814 POSTS

Bridging C and D would not show anything significant. It would only stop the PCM from self adjusting the ignition timing while you are checking.adjusting the distributor.
Nov 16, 2010 at 12:35 PM