1994 Saturn SC1 clutch issues

1994 SATURN SC1
135,000 MILES • 1.9L • 4 CYL • FWD • MANUAL
Avatar
FORDLOVER87
  • MEMBER
  • 9 POSTS
We recently changed the transmission with another used one and its all installed we used the old clutch sleeve cylinder and master cylinder and even bleed it out like several fourms told us to and it has good pressure like they say it should but we still have no clutch pedal but you can place car in gear and trt start it and it tries to pull like it should just have no clutch any ideas
Jan 23, 2015 at 2:08 PM
Advertisement
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
I have seen this before if the pin on the clutch slave cylinder isnt put in the correct place before you twist it in you will have no clutch pedal and a inop clutch.The plastic clip on the end of the clutch slave is best to replace it when ever removing the slave and reinstalling it.it holds the rod in the correct place while installing it.You dont have to always replace it but if your not use to installing them without the clip it can be tricky sometimes. Thats only thing i can think besides a bad clutch slave master assembly or the clutch fork/throw bearing wernt in the correct place.
Jan 23, 2015 at 6:57 PM