94' SATURN SL

Use an ohmmeter/DVOM or Analog -Read the resistances of the CTS hot/cold, if its not within specs replace it-

Here's a picture of the location

Just to add to this one your car has two sensor's the bottom one with the two wires is your coolant temp sensor that tells the computer what temp the engine is.There is a black wire which is grounded at the computer and the yellow wire is the 5 volt feed from the computer.Also inspect the connector to the sensor if it's corroded it will have to be replaced.Most of the time it's just a bad sensor pretty common on those car's.But i would also check the wires also.

awesome thanks. So....what would the resistance be across the pins? Or should it be of the sensor? It was a plastic tiped sensor. I ohmed out the harness. I was disapointed to see both wires had continuity to ground. Across my sensor pins i had 41 ohms.

The black wire on the connector is ground the yellow wire is 5 volt's you can see that in the wire diagram i posted.I have posted all the info you will need to trouble shoot your problem let me know what you find.






DESCRIPTION

The coolant temperature sensor (CTS) is a thermistor located in a coolant passage. When coolant temperature is cold the sensor has a high resistance, as temperature increases the resistance of the sensor decreases. The PCM provides a five volt signal to the coolant sensor, which is also connected to PCM ground. The PCM reads the voltage drop on the signal line to determine coolant temperature.

CODE PARAMETERS

Code 15 will set if:

* The CTS reads below -35°C (-31°F).
* The engine has been running longer than five minutes with a temperature less than -35°C (-31°F).

DIAGNOSTIC AIDS


* Refer to Temperature vs. Resistance Chart.
* When attempting to diagnose an intermittent problem, use the Scan Tool to review supplemental diagnostic information. The supplemental data can be used to duplicate a problem. Select MALF History from Scan Tool EC menu.
* Check the tightness of the female terminal grip with a spare male terminal.
* Start engine and observe CTS reading on Scan Tool.
* Normal operation is for the CTS to rise smoothly to approx. 88°C (190°F) (thermostat opens) then stabilize.
* Visually inspect CTS wires for damage. Wiggle wires while observing scan tool CTS reading and watch for a sudden shift in temperature.
* CTS may be compared to ATS temperature, with a Scan Tool if engine has cooled overnight at ambient temperature. They should be within four degrees of each other with ignition On - engine Off