Clutch replacement

1994 NISSAN HARDBODY
2WD • MANUAL
Avatar
ALASKADOR1
  • MEMBER
  • 1 POST
hi! i'm planning to replace my clutch. if i replace my clutch is there any adjustment on the pressure plate or just put it in just like the original setup? thanks! rene
Dec 24, 2010 at 9:46 PM
Advertisement
Avatar
MHPAUTOS
  • CERTIFIED EXPERT
  • 31,937 POSTS
Just bolt it up as the old one came out, make sure that you have the flywheel machined as if you don't you may have shudder problems, use a clutch aligner and replace the spigot bearing in the end of the crank shaft as well.

mark (mhpautos)
Dec 29, 2010 at 8:50 AM