How to get codes? it doesn't seem to have any DLC connector

1994 HONDA ACCORD
Avatar
EMMAYO
  • MEMBER
  • 34 POSTS
Can a 1994 Honda Accord be scanned for DTC. If yes how do i go abt it as it doesn't seem to have any DLC connector
Sep 28, 2011 at 7:14 PM
Advertisement
Avatar
ASEMASTER6371
  • CERTIFIED EXPERT
  • 52,796 POSTS
on the right front kick panel, there is a 2 wire connector that needs to be jumped and the code flashes out using the check engine light. it is a 2 digit code with a pause between the numbers. get those and get back to us.

https://www.2carpros.com/articles/honda-car-1990-1995-obd1-code-retrieval-procedure-and-definition-table

Roy
Jan 3, 2020 at 5:51 PM
Avatar
EMMAYO
  • MEMBER
  • 34 POSTS
Thanks a million for your quick response but i'm not too sure of your terms- right front kick panel- is it under the steering? And pls note i'll be using a Autoboss scanning machine to scan
Jan 3, 2020 at 5:51 PM
Advertisement
Avatar
ASEMASTER6371
  • CERTIFIED EXPERT
  • 52,796 POSTS
passenger side under the dash toward the door. remove that small kick panel and it should be there. never used the autoboss. just used a cotter pin. connector on the rf kick panel it has 2 wires and need to jump them with the key on. the codes will flash. get the codes and get back to us.

Roy
Jan 3, 2020 at 5:51 PM
Avatar
EMMAYO
  • MEMBER
  • 34 POSTS
i'll look into it. when i do i'll get back to you
Jan 3, 2020 at 5:51 PM
Avatar
ASEMASTER6371
  • CERTIFIED EXPERT
  • 52,796 POSTS
good luck
Jan 3, 2020 at 5:51 PM
Avatar
EUGENEPETER
  • MEMBER
  • 3 POSTS
Is it possible to get a fault code from my Accords computer even though it is a 1994 4 cylindere engine? If so, how do I get the code?
Thanks
May 17, 2021 at 1:07 PM (Merged)
Avatar
OBXAUTOMEDIC
  • CERTIFIED EXPERT
  • 3,711 POSTS
Hello,

PROCEDURE:
When the Check Engine warning light has been reported on, turn the ignition on, move the front passenger seat to the rear position and observe the LED on the front of the ECU. The LED indicates a system failure code by blinking frequency. The ECU LED can indicate any number of simultaneous component problems by blinking separate codes, one after another.

If output indicates CODE 4, 11, 15, 16 or exceeds 17, count the number of blinks again. If the indicator is in fact, blinking these codes, substitute a known-good ECU and recheck If the indication goes away, replace the original ECU.


Diagnostic Trouble Codes - 1994
Honda
1 Primary Oxygen Sensor (HO2S).
3 Manifold Absolute Pressure Sensor (MAP).
4 Crankshaft Position Sensor (CKP).
6 Engine Coolant Temperature (ECT Sensor).
7 Throttle Position Sensor.
8 Top Dead Center Position Sensor (TDC).
9 No. 1 Cylinder Position Sensor (CYP).
10 Intake Air Temperature (IAT) Sensor.
13 Barometric Pressure (BARO) Sensor.
14 Idle Air Control (IAC) Valve.
15 Ignition Output Signal.
16 Fuel injector.
17 Vehicle Speed Sensor (VSS).
20 Electric load detector.
21 VTEC Solenoid Valve.
22 VTEC Pressure switch.
30 A/T FI signal A.
31 A/T FI signal B.
41 Oxygen sensor heater.
43 Fuel supply system.



.
May 17, 2021 at 1:07 PM (Merged)