What all have you replaced? Have you replace the module for the distributor? The module in 94 is on the drivers side fender on a heat sink. Get back to me and I will look through my Ford program and see what we can figure out from there ok.
Jun 24, 2014 at 8:34 AM
RONNY FREEMAN
MEMBER
6 POSTS
I had the module checked and they say it's good there is a remote starter on the truck that we bad months before I had this problem could this have anything to do with my problem
Jun 24, 2014 at 4:36 PM
RACEFAN966
CERTIFIED EXPERT
5,029 POSTS
Usually no, if a remote start locks in theft mode it will usually stop the starter from working so you would only get a click and nothing more. So when you say no fire do you mean power to the distributor but no spark to the spark plugs? Get back to me and let me know what all you replaced too so we don't repeat stuff that didn't work ok.
Jun 25, 2014 at 8:32 AM
RONNY FREEMAN
MEMBER
6 POSTS
I've had the module checked changed cap and rotor
Jul 5, 2014 at 1:42 PM
RACEFAN966
CERTIFIED EXPERT
5,029 POSTS
Ok so is there spark to the spark plugs or not?
Jul 6, 2014 at 7:21 AM
RONNY FREEMAN
MEMBER
6 POSTS
Their is no spark to the spark plugs
Jul 6, 2014 at 2:43 PM
RACEFAN966
CERTIFIED EXPERT
5,029 POSTS
Ok you said you replaced everything I understand you replaced the ignition module, and distributor, what else did you replace? I need you to do an ohm test on the coil if you would. Do a ohm reading from + to - and then do one from + to the center (where coil wire plugs on) and - to center get back to me with that and I will see if it is in spec.