I have the upper timing cover off, do I need to remove the lower section? How many bolts in the pump? How do I remove the timing belt?
Nov 30, 2011 at 8:46 PM
How do I change the water pump on a 1993 protege dx model sohc 4cyl
1993 MAZDA PROTEGE
MOOSEHUNTER429
- MEMBER
- 2 POSTS
- FOLLOW
Advertisement
Removal & Installation (SOHC)
Drain engine coolant. Disconnect negative battery cable. Position No. 1 cylinder at TDC of compression stroke. Remove right side cover and undercover. Remove drive belts and water pump pulley. Remove timing belt.
See TIMING BELT under REMOVAL & INSTALLATION. Unbolt water inlet pipe from water pump. Water pump inlet pipe has lower radiator hose and by pass pipe attached to it. Remove water pump. To install,
reverse removal procedure. Tighten bolt to specification. See TORQUE SPECIFICATIONS. 14-19 ft lbs on pump bolts.
Drain engine coolant. Disconnect negative battery cable. Position No. 1 cylinder at TDC of compression stroke. Remove right side cover and undercover. Remove drive belts and water pump pulley. Remove timing belt.
See TIMING BELT under REMOVAL & INSTALLATION. Unbolt water inlet pipe from water pump. Water pump inlet pipe has lower radiator hose and by pass pipe attached to it. Remove water pump. To install,
reverse removal procedure. Tighten bolt to specification. See TORQUE SPECIFICATIONS. 14-19 ft lbs on pump bolts.
Dec 1, 2011 at 12:34 AM