1992 CHEVROLET LUMINA
243,000 MILES
Avatar
WOLFMAN1ME
  • MEMBER
  • 2 POSTS
Why does my neutral safety switch keep showing a fault code when it appears to be working fine. Have noticed it losing power and back firing spuraticly when cruising. Code for cam sensor also came on replaced it. No avail. Have replaced all sensors but temp, and crank. New ignition control module, and ECM(computer), plugs. What could be causing the spuratic power lose and popping and ?faulse neutral safety switch code, cause neutral safety switch is only 1yr old too. ???
Nov 18, 2012 at 11:54 PM
Advertisement
Avatar
ASEMASTER6371
  • CERTIFIED EXPERT
  • 52,796 POSTS
code numbers never identify bad parts just failed systems. we need the code numbers and we can give you the flow charts for the codes.

Roy
Nov 18, 2012 at 11:55 PM
Avatar
WOLFMAN1ME
  • MEMBER
  • 2 POSTS
Codes given are: DO342 cam signal circuit ?? Has new cam sensor, codes cleared, still comes back.
---DO705 neutral saftyswitch/trans range switch malfunction. Also new switch of one year old. Code also came back after clearing.
---PO117 Engine Coolant Temp Sensor/Low.. This is cause I know I need a new thermostat after an over heat from vandals cutting radiator hose, it's most Likely stuck open cause my guage is showing low temp. This code however never came back.
???? Could ECM have gone bad again ???? Or ---wire short from over heating??
Nov 19, 2012 at 11:07 PM
Advertisement