car problem

How long since a tune-up? Any applicable trouble codes? Use a gage and check fuel pressure. With TBI fuel system, you have to tee the gage into the supply line.

i wanna say i had one when the motor was replace and that was like a year ago what else could it be other than a tuneup

Check fuel pressure. With TBI around 10 psi. What about the trouble codes? You can check mil codes yourself. You place a jumper wire between A & B terminals at the datalink connector, turn key just till dash lites come on, no further, no crank. The mil starts flashing, you count the flashes to get the codes. Your looking for two digit codes. You need to do a little testing, otherwise, I'm not sure how to help?

ok i change the wires and plugs i can get it to crank but it want stay idle on its own

With idle issues, you start by cleaning the throttle-body and check Iac. What about trouble codes and fuel pressure?

I forgot to mention some things it takes bout a min before im able to get it started and when it starts i have to keep gasing it it seems like it wants to shut of when i mash down on the gas like it cant breath or sumthang and the car want run on its on son im not able to get the codes and my check engine light not on i really dont know to much bout getting codes but my buddy to me it needs to be running to be able to get the code and what too do i need to get the codes and to check gas pressure

My earlier post, I told you how to get the codes. The vehicle should not be running. The diagram shows location of A & B terminals at data link connector. To check fuel pressure, you take fuel supply line loose from throttle-body, tee in fuel pressure gage for TBI system. Some of the national brand autostores used to loan out a TBI fuel pressure gage. I know they have a gage to fit schrader valve, not sure about TBI, you can ask.

my code is 12

That means diagnostic mode, any other codes. What about fuel pressure? With TBI, I've seen injector spray patterns that looked good to me, but the fuel pressure was half of what it should have been.

what do you mean by diagnostic mode and that was the only code and i havent got the tool yet to check the fuel pressure

A code 12 can mean no rpm signal, but, if you think about it, with key on engine off, there isn't an rpm signal, no rpms. That is usually the first code that flashes, even if there are no problems. May flash three times, then goes to the next code, if there are any.

so it wouldnt be the distributor

I can't rule out anything at the moment. The first things I check are good spark and fuel pressure. You can also check compression. Depending on the vin, ignition timing may not be adjustable.

how do you adjust the ignition timing

I need your vin, to know if it is adjustable. The vin should be on driver side dash, close to windshield. Look through windshield to find it.

the car is fix it was the fuel pump now i have the fuel light on and my fuel gauge says empty how can i fix that problem

Did you put some gas in it? Maybe a faulty sending unit? Try the procedure below.

Maybe a problem with sending unit? Does it have gas in it? Try the procedure below.