1991 Oldsmobile Ciera crank but no spark

1991 OLDSMOBILE CIERA
164,000 MILES
Avatar
MIKESMITH2107
  • MEMBER
  • 4 POSTS
i recently replaced the engine on my car, i also replaced the crank position sensor, knock sensor. when i crank the vehicle i am getting no spark to the plugs. i have power going to the ignition control module. i have check grounds, changed coil packs. what else could cause no spark?
Sep 21, 2013 at 12:10 PM
Advertisement
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
scan for codes first
Sep 21, 2013 at 1:47 PM
Avatar
MIKESMITH2107
  • MEMBER
  • 4 POSTS
at first i had a knock sensor code, replaced it and code went away. that was the only one that showed up. I am about to change the cam positioning sensor and see if that works.
Sep 21, 2013 at 8:53 PM
Advertisement
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
check fuses underhood and dash proior to changing parts. then check resistance of cam sensor as it may be ok then take ignition module to auto parts and see if tha tis good. they can check it.
Sep 22, 2013 at 5:46 AM
Avatar
MIKESMITH2107
  • MEMBER
  • 4 POSTS
where are the fuses under the hood, checked all the fuses in the glove box, all where good, havent checked the relay's yet. ignition control module was checked at auto zone , and passed all of them.
Sep 22, 2013 at 2:16 PM
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
sorry screwed u pon that one car is old so you forget. it's fuse 1 in car. also fuse2 check with attest light
Sep 22, 2013 at 3:19 PM
Avatar
MIKESMITH2107
  • MEMBER
  • 4 POSTS
all fuses are good
Sep 25, 2013 at 11:57 AM
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
do wha ti said in first reply then go to how to repair to find out what system is screwd up cross A&B on aldl and watch serive engine ight flashes it does a series of 3 I time then 2 +12 etc. you stil haven't don e that
Sep 25, 2013 at 12:43 PM