Daytona Front Lights Of This Car 1991

1991 DODGE DAYTONA
50,000 MILES
Avatar
AVALANCHE1111
  • MEMBER
  • 5 POSTS
Daytona Front Lights Of This Car 1991 motorheadlight get no negatief power just positief on the 2 wires from a unit in the center of the dashboard.the light self work fine.The unit turns on en after 3sec turns off by lights on or highbeam bad sends 2 wire positief to the motor at te same time
Sep 26, 2011 at 9:36 PM
Advertisement
Avatar
ASEMASTER6371
  • CERTIFIED EXPERT
  • 52,796 POSTS
if there is power on the negative side. there is no ground. you should have no voltage on the negative side.

Roy
Sep 26, 2011 at 10:13 PM
Avatar
AVALANCHE1111
  • MEMBER
  • 5 POSTS
the power switches normaly on the motor open +-/close-+ by the unit.the unit have positief en ground.still it don't work i even replaced the unit,same result.how does this unit work(schema)?
Sep 27, 2011 at 12:28 AM
Advertisement
Avatar
ASEMASTER6371
  • CERTIFIED EXPERT
  • 52,796 POSTS
take a look at this and see if it helps

Roy
Image (Click to enlarge)
Attached Media
Sep 27, 2011 at 3:08 AM
Avatar
AVALANCHE1111
  • MEMBER
  • 5 POSTS
Thanks, but i need to now how this unit works,witch signals does it need to work properly.
Sep 27, 2011 at 7:32 AM
Avatar
ASEMASTER6371
  • CERTIFIED EXPERT
  • 52,796 POSTS
it works from a signal from the headlight switch which triggers the operation of the door.

Roy
Sep 27, 2011 at 2:07 PM
Avatar
AVALANCHE1111
  • MEMBER
  • 5 POSTS
Thanks all,the probleme is solved.I had two defect units with the same probleme,bad solder joint at a lit from the relais.I found it on internet with the part nr Mopar 4503026 in google end you can find all the information how to fiks it.
Sep 28, 2011 at 10:30 AM