1990 Toyota Pickup code 43

1990 TOYOTA PICKUP
75,000 MILES • 2.4L • 4 CYL • 2WD • MANUAL
Avatar
MCDANIEL30
  • MEMBER
  • 6 POSTS
started vehicle ran for about 30 seconds then made odd sound and died will now crank but not start checked for spark thats good checked ignition its good has flash code 43 checked voltage of sta wire at ecu only .26 volts all other power and ground supplies at ecu are reading in spec
Jun 6, 2014 at 7:05 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • CERTIFIED EXPERT
  • 110,175 POSTS
You have 26 volts at the ECU? Are you sure? If you have a good spark, try something for me. See if the engine will start using starting fluid.
Jun 6, 2014 at 8:28 PM
Avatar
JACOBANDNICKOLAS
  • CERTIFIED EXPERT
  • 110,175 POSTS
Also, that code is for no starter signal to ecm, Have you checked all of the computer and engine grounds? If those all check good and clean it is possible that the pressure regulator is going bad causing a problem
Jun 6, 2014 at 8:34 PM
Advertisement
Avatar
MCDANIEL30
  • MEMBER
  • 6 POSTS
thats .26 as in less than a volt at sta wire at ecu connector, i checked all pins at ecu pertaining to grounds, main relays and anything tied to starting issue
Jun 6, 2014 at 8:43 PM