1990 Ford Ranger power steering pump

1990 FORD RANGER
2.9L • 6 CYL • 2WD • AUTOMATIC
Avatar
COUNTRY10
  • MEMBER
  • 3 POSTS
i have a 90 ford ranger.my power steering pump is leaking around the threads where it screws into the pump. i cant break the tap loose.is there anything i can put on the threads to stop it from leaking. thanks
May 21, 2015 at 5:29 AM
Advertisement
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
I assume it's the power steering line. there is an oring behind the line that is leaking more than likely try replacing it.
May 21, 2015 at 5:42 AM
Avatar
COUNTRY10
  • MEMBER
  • 3 POSTS
hello,yes its leaking fluid from the power steering line. since i cant get the tap broke loose that goes into the pump, how can i replace the oring?
its on a 90 ford ranger.thanks
May 21, 2015 at 7:10 AM
Advertisement
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
try heat fro a propane torch hold large nut if there is one then make sure to use a line wrench to loosen so you don't screw up the fitting a propane torch won't get that hot on fitting. or if you have a small butane torch is better as it has a smaller flame. the most you will do is wreck the oring which you are going to replace anyhow. If things are in the way take off pump to get it out of the way
May 21, 2015 at 8:17 AM