dies it looks to be getting fuel and starts right back up?

1990 CHEVROLET SILVERADO
10,000 MILES
Avatar
HAMERLANER
  • MEMBER
  • 3 POSTS
truck has 5.7 in it I have changed dist pick- up dist module oil pressure switch coolant senser the truck stats good but you put it in a pull and it dies it looks to be getting fuel and starts right back up
Jan 4, 2013 at 6:33 PM
Advertisement
Avatar
JDL
  • CERTIFIED EXPERT
  • 16,098 POSTS
How long since overall tune-up? Use a gage and check fuel pressure. Are there any applicable mil codes? You can check mil codes, yourself. You use a jumper wire between the A & B terminals at the datalink connector. Turn key just till dash lites come on, no further, the mil on the dash starts flashing, you count the flashes to get the codes. Your looking for two digit codes. Let us know what you find.
Jan 4, 2013 at 7:09 PM
Avatar
HAMERLANER
  • MEMBER
  • 3 POSTS
iI failed to report new plugs wies cap rotor and fuel pump also
Jan 4, 2013 at 7:29 PM
Advertisement
Avatar
HAMERLANER
  • MEMBER
  • 3 POSTS
all i get is code 12
Jan 4, 2013 at 7:48 PM
Avatar
JDL
  • CERTIFIED EXPERT
  • 16,098 POSTS
You still need to check fuel pressure. Do a cylinder compression test. Make sure the exhaust isn't clogged.
Jan 4, 2013 at 8:08 PM
Avatar
HAMERLANER
  • MEMBER
  • 3 POSTS
fuel pressure 12 pds comp 130 there is one cyl. at 120 exhaust is 3 in striat pipe it's got to be something simple would mapp senser cause any of this
Jan 4, 2013 at 8:29 PM
Avatar
JDL
  • CERTIFIED EXPERT
  • 16,098 POSTS
I don't know what else? A sensor problem should have set a code. I've seen instructors say about sensors, when in doubt, take it out, meaning unplugged it. The computer may default to a preset value, allowing the vehicle to run.

Unplugging sensors may be poor diagnostics, but?
Jan 4, 2013 at 9:45 PM