1988 CHEVROLET SILVERADO
234,566 MILES
Avatar
CHEVYUP
  • MEMBER
  • 5 POSTS
i replaced the engine in my silverado , when i put the transmission in gear the engine will die,it idels fine and will idle all day long , ive done complete tune up changed map senser idle air contol,electic spark control valve
Apr 10, 2013 at 3:13 AM
Advertisement
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
scan for codes aand check fuel pressure if tbi 9-11psi fp. check gasket under tbi for being blown.
Apr 10, 2013 at 2:22 PM
Avatar
CHEVYUP
  • MEMBER
  • 5 POSTS
Checked all that, it is good, truck will start up with the tempurture sending unit hooked up, if i discnect the tempurture sending unit it will idle fine when in gear, Scaned for codes I got a number 15, tempurture sending unit I replaced the unit ,But that did not fix the problem, any ideas IM REALLY GRASPING FOR ANSWERS NOW
Apr 16, 2013 at 7:07 AM
Advertisement
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
when you disconnect temp sender truck goes to open loop and computer only runs it as a rich engine cycle.did you just replace the engine or did you transfer stuff from old truck to different/newer motor. that may be the problem. recheck your installation for wires disconnected like wire to check timing, or any pinched wires.
Apr 16, 2013 at 7:57 AM