It take many turns of the key to start the truck

Hope the diagram is helpful.

This is great thanks, one more question, the rod like in this diagram is sticking straight up, the switch when installed the slider is at a right angle to the rod. To get the rod into the slider the rod would have to rotate 90 degrees and it doesn't want to do this. Is the rod suppose to rotate to go into the slider?

Thanks Ron

I have not done this before so am not able to provide you with any instructions but here are 2 different methods depending on the type of switch used.

Type 1.
To install, move switch slider to far left position and then 2 detents to the right on non key-release switches. On key-release switches, move switch slider to the far left position. On all types, position rod in hole and install switch to steering column.

Type 2.
Place lock and switch in "LOCK" position. Install actuating rod into switch and install switch using mounting screws. Tighten slowly. Ensure switch position is not changed.

Thanks I figured it out. It was staring me right in the face!

Ron

remove the switch plug in the new 1.use a screw driver in the slot.it should slide foward and start the car.pull it back it gos to accesory.