1988 Chevrolet Camaro Rear Axel Bearing

there are two different types one is borg warner an dother is gm. you need to seeif axle has 4 bolts holding axle on near caliper. I am sending instructions for that one .
Raise and support vehicle. Mark position of wheel on axle. Remove rear wheels. Remove caliper mounting bolts and support calipers from vehicle frame. Remove disc rotor. Remove 4 nuts holding dust shield and outer bearing retainer.
Attach Axle Shaft Remover (J-21597) to axle shaft. Using a slide hammer, remove axle shaft and wheel bearing. Mount axle shaft in soft-jawed vise. Using a chisel, split inner bearing retainer and remove from shaft.
Using Axle Bearing and Retainer Remover (J-22912-01), press bearing and seal off axle shaft. Discard bearing and seal. Bearings and retainers must not be reused.