tune up specs and procedure

1986 MAZDA B2000
4 CYL • AWD • MANUAL
Avatar
JIMMY WASHINGTON
  • MEMBER
  • 1 POST
I have just replaced the head on my engine and need to I set valves,and ignition timing on a 1986 mazda b2000 2.0l. I need the specs as well.
(It ran hot and cracked the head, I have done this type work many times but i don't have the specs and do not know if i need to disconnect a wire on the distributor to iscolate the advance.
Jan 1, 2011 at 4:23 PM
Advertisement
Avatar
MOBILE MAN CAN
  • MEMBER
  • 1 POST
Assuming that you've already brought the number one cylinder to Top Dead Center,and have lined the timing marks of the balancer (crank pulley), on the b2000 cam spocket there will be four numbers in series: 1,2,3,4, or alphabets A,B,C, and so forth. The number one represents the number one piston at Top Dead Center when it is lined up with the arrow that is found above and behind the camsprocket where the timing cover bolts to. This times the cam sprocket. There is a vaccum hose going to the distributor (this is for the vaccum advance) that must be disconnected and plugged before ignition can be timed. You can get detailed photos at http://torquespecs.tripod.com/mazda_trk_72-93_eng2.htm

Mobile Man Can ASE Certified Techs
Image (Click to enlarge)
Attached Media
Dec 5, 2011 at 5:37 AM