sould i cut out center ports on new paper 455 intake gaskets

1971 OLDSMOBILE 442
Avatar
OLDSMAN44265
  • MEMBER
  • 3 POSTS
replacing my stock intake w/ allum. intake and new paper gaskets have one less hole in center of head than old valey pan gasket
Sep 19, 2011 at 11:57 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • CERTIFIED EXPERT
  • 110,175 POSTS
You should be able to do it as long as there is enough room around the area.
Sep 20, 2011 at 12:17 AM
Avatar
OLDSMAN44265
  • MEMBER
  • 3 POSTS
do you think it will affect the operation of the motor?
Sep 21, 2011 at 12:52 AM
Advertisement
Avatar
JACOBANDNICKOLAS
  • CERTIFIED EXPERT
  • 110,175 POSTS
It souldn't as long as it doesn't cut into something other than just for the stud. We normally only recommend direct fit parts because it is hard to tell what may happen when we aren't there.
Sep 21, 2011 at 2:11 AM
Avatar
DOCFIXIT
  • CERTIFIED EXPERT
  • 18,828 POSTS
No need to cut allum intake does not need exhaust gas pass through as cast does it will heat up cutting out intake will get to hot and can cause gas to boil in carb
Sep 21, 2011 at 5:44 PM